Posted by larbear on May 28, 2020 at 18:00:54 from (66.180.70.44):
In Reply to: Baling tractors posted by DeltaRed on May 28, 2020 at 07:01:48:
I'm able to use my Dad's new in 61 Dexta Fordson 2000 on a NH 67 hayliner but not lately. Rounds are nice 5x6 on a Gehl 1840 I believe as I'm not looking at the number. I bought a 706 D to run the round baler but the tractor has mcv and a sprague clutch issue which I am about to get into, though I find another job for it seems before I get there. I'm blessed to be able to use my Brothers 7700 JD on the round baler. It is nice with the transmission but I am doing some lots that are convoluted, it's a big tractor for that. Found a NH 905 swather not far from home, a gasser but in good shape seems like. I'm hoping it will be good around the lots as far as not tramping too much. SW Ontario, we are 3-4 weeks to our first cut though the weather is the dictator.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
