I havent taken the cover off to look...yet....i do believe that yes somehow 2 are getting together,,,,,have never been into a tractor gearbox but have many other machines,,,,cars,motorcycles and so on...just brainstormin i my mind but from my exp you have the outter drive teeth and manytimes inner dogs i will call them that engage on whatever and because of the angle machining pressure pulls the gears together.....why i was wondering if the 1st and rev were in fact the same gear,,,it engages one way for first and opposite for rev.....and.....if i do need to replaced a gear or whatever,,,,,,do I have to split the tractor or can i remove the aft cover and possibly slide gearshafts aft enough to removed the gears?...Just hopeing to find 140 info because i would bet there are no old timer mechs in my area anymore who have been into and know a 140 xnsmission....all have past on. Tryin to minimize what might not be a major major job. Its kinda makes ya sick when you tear somethin all to pieces only to find afterward heck i didnt need to do all that. again thanx for the responce and again any info is appreciated.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
