Posted by PJH on May 07, 2020 at 10:15:36 from (50.45.13.127):
In Reply to: Re: Old wives tales? posted by 37 chief on May 06, 2020 at 20:07:41:
37 Chief - I worked one winter on a bridge construction project. They had an ancient welder on a trailer that was powered by a Wisconsin engine. The carpenters welded the piling splices and ran the welder. It would almost but not quite start one cold morning, and the two carpenters cranked until they were wore out, with the foreman making fun of them the whole time. Finally, every man on the job had tried to start it and had failed, with the foreman still running his mouth. He was a strong man, and he was gonna demonstrate how to start that thing. I'll have to admit, he could whip that engine over, and it wanted to run, but not on its own. What we (and he) didn't realize was that he was pulling the crank off of the crankshaft as he cranked, and when it did come off, the crank end flew around and hit him on the chin. He fell like an oak tree and just laid there. We all thought it was the funniest thing we'd ever seen, until it dawned on us that we'd better check his pulse. He was still ticking, so we drug him by the heels over by the fire barrel and he slowly came to. Every morning thereafter, we'd holler up to Bill the foreman to come down and show us how to start that welder.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review: JB Weld - by Staff. JB Weld is basically an epoxy glue that does an exceptionally good job of bonding to cast iron and steel along with several other materials. As I mentioned, it is so common that I have yet to buy a tractor that did not have JB Weld used somewhere. It is sometimes used so well you can't tell its there and other times used as a sloppy quick fix. Finding where and how it can be used correctly is key to whether you are using it as an "inelegant hack" or an integral solution to difficult and expens
... [Read Article]
Latest Ad:
WANTED Front grille/nose assembly for Massey Ferguson 1160 (also fits 1180 & 1190). Headlight-mount section. AGCO Grille 3706022M91 (supersedes 3705942M91), cover 3705494M1/M2, holders 3705501M91/3711158M92. New/NOS/good used OK. Jonesboro, AR - will pay shipping. Photo appreciated. Thanks
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
