Posted by John T PS on April 29, 2020 at 10:02:33 from (45.16.200.171):
In Reply to: Re: Amps vs watts posted by Geo-TH,In on April 29, 2020 at 09:14:20:
George, FYI there is no simple equation (way to may factors and variables and unknowns) I can give you for the starting current of a motor. Let me explain this for you.
Such requires complex physics, mechanical considerations, weights, inertia, starting load and torque, efficiencies on and on and on and YES a current motor design electrical engineer or when I was an engineer at Century Electric I could tell you for a certain motor based on the initial load BUT I CANT GIVE YOU ANY SIMPLE EQUATION THEN OR NOW. The equation for Watts is Volts X Amps but it takes moreeeeeeeeee then that to compute starting current...….
I can tell you as an electrical engineer and a former engineer at Century Electric Motor Company the current to START a motor may be 3 to 5 times or even more then running current GET IT ?????????
Im not sure I understand your challenge??? A person can use a 12 VDC motor orrrrrrrrrrrr a 120 VAC Compressor and an Inverter orrrrrrrrrrrrr a Gas powered Compressor. Theres no "My Way or the Highway" when it comes to a persons free choices, you use what you like and others should do the same. Im not here to argue only to help educate you and others, but Im not perfect I cant explain in a sentence what takes years of study and training to comprehend so dont feel bad if you don't understand it
I will help you the best I can neighbor
Best wishes God Bless and protect you and your family George. As always its a pleasure chatting with you and trying my very best to help
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
