Posted by JK-NY on April 08, 2020 at 05:23:45 from (174.197.202.146):
In Reply to: Re: Haybine is alive posted by Bruce from Can. on April 08, 2020 at 03:01:38:
That is sound advice. I use a bolt for a pin on the haybine with the nut on top so there�s nothing to hang down and catch the hay . I also put a couple three big washers on top of the tractor drawbar to hold the haybine hitch up closer to the tractor drawbar on the bottom side. This is only really necessary if you put the hay in a tighter windrow as opposed to nearly full width. If the 960 Ford is the mowing tractor the front wheels may mash down the hay so catching hay might be less of an issue. I also remove the jack once I get right at haying as I have had the jack handle drop down and drag hay. Just think - Grandpa Love - if all of us that have been making hay for a while keep telling you all the things we learned the hard way- you�re off to a good start. You may never know the joy of hay wound around the pto shaft that goes from hardly any thing to solid all the way to the tractor in no time. I also think you have a good idea to try out the equipment before you actually get started- especially if you are going to be a ways from home on the fields you have lined up. It always seems like equipment issues, tire problem etc always wait to happen till you are farther from home.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Case VA Series - by Staff. V, VC, VI and VO). Althouh the Case VA looked much like the V, it shared no major components with its predecessor. Except for military units, the production of the Case VA was interrupted in July of 1942 due to World War II. It resumed again in 1944 and continued until 1953. It started up briefly later on in 1953 and continued on a very limited basis until 1956. The VA Series included the following models: VA: Fixed front wheel tread VAC:
... [Read Article]
Latest Ad:
Massey Ferguson model 65 diesel tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
