Posted by kcm.MN on April 05, 2020 at 15:19:04 from (174.219.147.34):
In Reply to: Computer question posted by J. Schwiebert on April 05, 2020 at 14:59:51:
He sent pics from his phone to your computer? Was that using email?
Depending on how the pics were sent, sometimes they are simply very small files. Hover your mouse over the pic. A small screen should appear, and the last line should say what the Size is. If it's under 100KB, that's pretty small.
In any case, you can save it to your hard drive (saving to Desktop is likely easiest) and then open the pic using Paint. Once open, you can click on Select, choose All, then click on Resize (just to the right of Select). If not already chosen, select Percentage. Both boxes below that will show 100, for 100% size. Change either number and hit enter -- start by making the number 150. If it's not too blurry and you want to go bigger, then hit the back arrow (takes you back to original size) and then Resize to 180 or whatever you want to try. When you get it where you like it, hit the Save icon (very top-left and looks like a floppy disk).
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.