Posted by ram74 on April 03, 2020 at 12:25:13 from (165.214.11.93):
Hi all, wrapping up construction on the pole barn. I put one overhead door on each opposite end so I could drive the hay wagon straight through for loading/unloading. I didn't account for sight slope and the exit door is about 2 feet above grade. The builder piled some excess stone there and was driving his kubota in and out but it is too steep for permanent use. I guess the length of the rock pile is about 4 feet max. the sight continues to slope gradually out from where the ramp would be. I figure i could either move that stone or add to it and build it out.
What should I do with this ramp? Is it ok to just keep piling stone there and maybe top it with flume or #53 to lock it together? what is a realistic slope and length of the 'ramp'? I want to be able to drive either the 8n or the ram2500 through there pulling the hay wagon. The truck has a large clearance due to the factory lift, maybe 15 inches or so.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
