Posted by Janicholson on April 01, 2020 at 10:17:11 from (24.240.46.228):
In Reply to: Bale wagon posted by TDJD on April 01, 2020 at 09:21:57:
If the wagons don't have stake pockets that is the first task. Substantial reinforced pockets are necessary if you intend to remove and replace the sides, and use them for a Kicker. Look at bale wagons made for the task on line. Your easy on/off, light structure is really difficult to achieve. Bales make serious projectiles. My thinking is to use 2X4 upright stakes made from knot free white pine or spruce. Steel L brackets can be bolted to the top on cross "Roof" rafters (on edge, not flat). Once they are in place, diagonal braces made from 1" X 1/4 " steel strap, must be used to create shear strength from corner to corner on left right top and back sides in the form of an X. Again bolted with washers, not lag screws on each upright. The open front needs to have smaller gussets on the top corners to prevent wracking from left to right. Probably 3 feet on the hypotenuse. I don't know what your skill set is, or what you know about strength of joining wood to wood, so I will say two 5/16 bolts and washers (no lock washers) into each piece is minimal to keep things from rotating on a single bolt. The strength comes from flexability in this idea, not rigidity. Good luck, Me, I would buy real catch wagons, or hire high school kids! or make the cages permanent. Jim
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Pitfalls of Tractor Engine Rebuilds - by Chris Pratt. The first pop after you have put the machine together with your own hands is exciting and pleasing. The whole experience can be marred if one moves too fast and makes too many assumptions that they can just use "as is" some parts they should be closely scrutinizing and possibly attended to. In such cases, rework makes what could have been a fun project turn into an irritant or even a nightmare. Minor Irritants To give you an example of an minor but irritating proble
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
