Posted by Northvale PA on March 24, 2020 at 08:40:33 from (107.77.204.98):
In Reply to: MF 1359 discbine posted by 2510Paul on March 24, 2020 at 08:10:41:
I have a NI 5209 and I think it is a great machine. Mine are rubber rolls. Overall, the pros and cons are as follows: it is a lighter machine than NH. But I run a JD 4020 which is now over 50 years old. I want a lighter machine to avoid hurting the tractor. I wanted 9� wide since my rakes and tenders are that size too. My fields are smooth and clean. I sharpen the blades constantly. The cutter bar drive shaft is known to be light and twist under impact loads, but I think I have avoided that problem. I did drive thru a big ground hog mound last year and felt everything lug down. That type thing could twist the cutter bar shaft. There may be improvements on the later machines than mine but I am not sure. Overall, performance and simplicity of the components is good. Thick wet hay is no challenge at all.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Brief History of Tractors in Australia - by Bob Kavanagh. After Captain Cook's exploration of the east coast in 1770 the British Government decided to establish a penal colony in Australia. The first fleet arrived in 1788 and consisted mainly of convicts who were poorly equipped and new little of farming techniques. The colony remained far from self-supporting and it was not until the early 1800's that things started to improve. Free settlers started to arrive, they followed the explorers across the mountains and where land was suitable set up farms. T
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
