That is why the commercially sold kits use straight threads i.e. Threaded rod or bolts or set screws.
Torquing a pipe plug will force the mother material apart.
On the other hand pipe plugs might not be a bad choice as long as they are turned in just enough to feel them get just a bit snug like one pinky on the outer end of a six inch wrench, lol.
Which would equal the mother metal refusing to spread out.
After all the bolt, set screw or threaded rod method have no torque at all applied/remaining other than thread quality.
But make dang sure you install the plugs well beyond where you think the crack ends. At least one maybe two diameters worth.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Little "M" - by Donnie Anderson. They call me "Little M" and this is my story. For the past several years I have sat against the tree-line, where my parts have rusted and rotted away. For all of these years I have wondered just exactly what happens to old tractors? Times were not always like this. I can remember back to 1948 when I was a brand new John Deere Model M. A man and his wife came to the dealer and looked me over real good. After many talks with the salesman a deal was struck and I, along with a M2 plow, c
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
