Posted by Bruce from Can. on February 22, 2020 at 15:47:44 from (70.52.186.9):
Didn�t want to derail the post below about the broken pto pin spring and how to get it apart. So I have started a new post/rant about the tractor end connectors on pto shafts. I hate them ! You have to haul back on a stupid little collar on the yoke, at the same time as you are trying to shove the dang thing forward. Ok maybe it�s not too bad on smaller equipment with a light shaft, and warmer temperatures. But even with warm temperatures of summer with the shaft sliding freely, the sheer weight of holding up the shaft on the pto of my round baler, let alone shoving the shaft forward, while pulling the collar back is madding. And probably more than a older man or a gal can manage. And these collars are equally annoying when temperatures drop and the grease on the shaft doesn�t want to allow the shaft to slid, like when hooking up the snow blower. Rant over.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Grain Threshing in the Early 40's - by Pat Browning. The setting is rural Wisconsin, halfway between East Troy and Elkhorn, on Hodunk Road, our nation was at war, and I was 6, 7 and 8 years old. George was our "threshing neighbor." He was the one with the threshing machine, a JI Case on steel wheels, and he pulled it to our farm with a JI Case standard tractor also on steel. In those days, steel wheeled implements were common. The roads were general gravel, so the lugs cutting into them wasn't a problem. George would set up the thresher, s
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
