Posted by MarkB_MI on February 22, 2020 at 03:48:29 from (174.230.18.210):
In Reply to: shop heat question posted by wjytexas on February 21, 2020 at 08:14:23:
When I poured the floor of my shop I put insulation under the slab and ran PEX lines so I could add radiant floor heat at a later time. I haven't yet done that because I haven't finished insulating it. I expect to finish that job in a couple of weeks, then maybe this summer I'll get gas ran out to the shop and plumb up the floor heat.
Regardless of heat source, I think insulation is the key. Not just in the ceiling (or roof) and walls but also in the floor. That way the slab serves as a huge thermal mass that keeps the shop temperature fairly constant throughout the day.
I have a ceiling in my shop, but if you don't, consider putting a small ceiling fan under the peak of the roof to circulate the warm air when you have the heat on. It doesn't need to be very big to make a big difference.
While I'm waiting to get my floor heat hooked up, I use a torpedo heater to warm up the shop, then switch to a radiant kerosene heater. Although they get the shop warm enough to work comfortably, they add a lot of humidity, which leads to rusty tools, etc. So I definitely recommend using a vented heater of some sort.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
