Posted by JD Seller on February 16, 2020 at 10:57:08 from (208.126.198.213):
In Reply to: Re: Pressure Washers posted by Jim in N.M. on February 16, 2020 at 09:18:32:
Jim mine is 4 gpm with 3200 psi. I rarely use full pressure. I have the dual wand with a dump control handle right on the side of it. It dumps the pressure out the second tube. This way you can easily rinse things off with low pressure. Nice to wash around bearing and such.
Yes I use well water. I have a water filter mounted right on the washer frame. This keeps sand from plugging the nozzle. Since mine heats the water you have to worry about plugging the heating coil with hard water scale. I do not want to use a water softener on the shop circuit. Instead I mounted a unit/filter that adds a polyphosphate to the water. This chemically changes the hard water so it does not create scale inside the coil. Looks just like another filter but has a cartridge that slowly dissolves. The model I have is good for 100,000 gallons of medium hard water before you have to replace the cartridge.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
