Posted by caterpillar guy on February 03, 2020 at 19:16:59 from (47.26.95.42):
In Reply to: John Deere 4440 posted by Running H on February 03, 2020 at 18:33:39:
Unless you have a reason to pull a smaller one you can easily pull a 20 foot nothrill drill with a 4440. We pull a 15 foot Great Plains nothrill with any of the 3 806,856,2940 All pull it easily. I like the deere on it with the more hyradulics on it. Lifts faster on the ends. A Deere with the dolly wheel is a poor choice if you have wet ground to plant. That dolly wheel will sink like a rock with no bottom in site. Good drill otherwise. Most drills will plant wheat seed. Some will adjust small enough to plant alfalfa seed. Our GP will slow down and get small enough to plant it. Other wise if you want to plant the 2 together you will need a seeder attachment added to the drill it is a smaller seed box usually on the front of the regular seed box.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Reflections of the Fifties - by "Country" Elliott. I remember rowing up in the 1950�s in a small, rural town in northwestern New Jersey. The closest town to ours was only 3 miles away, and there were seven dairy farms in the areas of these two country towns. We had 5 acres, and because my Dad was a salesman and not a dairy farmer, he let the Bockovens, who owned the Willow Tree Dairy farm most of our land.
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
