Posted by The tractor vet on January 31, 2020 at 21:55:20 from (104.179.81.68):
In Reply to: Cylinder head removal posted by deltared on January 31, 2020 at 14:04:19:
Other ten ten Bizzllilon wires and hoses . It's not that big a deal . Looks worse then it is . Atleast it is a 6 and not a stuffed in big block . I would say that one from start to finish is a 6 to 8 flat beer rate job . NOW Maybe , just maybe if you had say three four inches of room between the head and fire wall and you could roll the old soft plug out with a little barn yard engineering you could make up a MINI press with say a 5/8th bolt a plug to fit the soft plug and a plate of steel as a back up to set agaist the fire wall to push against oR CLEAN THE HOLE OUT WELL AND DRY IT AND USE A RUBBER EXPANDING PLUG . SORRY NOT THERE TO SEE FOR MYSELF . SOME TIMES WE MUST DRINK THE SITUATION OVER AND THINK FIRST BEFORE WE ACT.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Farmall Story - by Ed Meadors. The year was 1978. Our young family had recently moved to rural Chesapeake, Virginia to a plot of land which would finally allow us to realize our dreams of a huge garden, critters and more lawn and pasture than we would ever use! We needed a TRACTOR; not a riding mower or tractor wannabe, but a real TRACTOR. The answer to our needs materialized in the form of a '44 Farmall A, complete with cultivators, discs, single plow, a 5ft.Woods belly mower and one, mounted spare 9.00x24 rear wheel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.