Posted by Mutt and Jeff on January 27, 2020 at 10:36:27 from (70.16.213.120):
In Reply to: Deep cycle battery posted by John in La on January 27, 2020 at 10:18:49:
Take it back and explain that it is in fact not (aparently) maintenance free.
Here's some reading and examples https://batteryuniversity.com/learn/ I suspect this is called shedding BU-804: How to Prolong Lead-acid Batteries Explore what causes corrosion, shedding, electrical short, sulfation, dry-out, acid stratification and surface charge
A lead acid battery goes through three life phases: formatting, peak and decline (Figure 1). In the formatting phase, the plates are in a sponge-like condition surrounded by liquid electrolyte. Exercising the plates allows the absorption of electrolyte, much like squeezing and releasing a hardened sponge. As the electrodes activate, the capacity gradually increases.
Cycle life of a battery
Figure 1: Cycle life of a battery.
The three phases of a battery are formatting, peak and decline.
Courtesy of Cadex
Formatting is most important for deep-cycle batteries. They require 20–50 full cycles to reach peak capacity and field usage does this. During breaking-in, manufacturers recommend going easy on the battery. Starter batteries are less critical and do not need priming. The full cranking power is available from the beginning, although CCA will go up slightly with formatting in early use. (See also BU-701: How to Prime Batteries.)
A deep-cycle battery delivers 100–200 cycles before a gradual decline begins. Replacement should occur when the capacity drops to 70 or 80 percent. Some applications allow lower capacity thresholds but the time for retirement should never fall below 50 percent as aging may hasten once past the prime.
To keep lead acid in good condition, apply a fully saturated charge lasting 14 to 16 hours. If the charge cycle does not allow this, give the battery a fully saturated charge once every few weeks. If at all possible, operate at moderate temperature and avoid deep discharges; charge as often as you can. (See BU-403: Charging Lead Acid.)
The primary reason for the relatively short cycle life of a lead acid battery is depletion of the active material. According to the 2010 BCI Failure Modes Study, plate/grid-related breakdown has increased from 30 percent 5 years ago to 39 percent today. The report does not provide reasons for the larger wear and tear other than to assume that higher demands on the starter battery in modern cars induce added stress. The organization conducts a study every 5 years to determine the failure modes of batteries that have been removed from service. (BCI stands for Battery Council International.)
While the depletion of the active material is well understood and can be calculated, a lead acid battery suffers from other infirmities long before plate- and grid-deterioration sound the death knell. These conditions are found under: Corrosion, Shedding and internal Short, Sulfation and How to Prevent it, and Water Loss, Acid Stratification and Surface Charge. Most of these can be reduced by proper handling.
Summary As battery care-giver, you have choices in how to prolong battery life. Each battery system has unique needs in terms of charging, depth of discharge and loading that should be observed. The following papers summarize what batteries like and dislike.
BU-415: How to Charge and When to Charge? BU-706: Summary of Do’s and Don’ts BU-806a: How Heat and Loading affect Battery Life
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Updatin The Charging System of Your Older Tractor - by Tyler Woods. Older tractors have externally regulated generators or externally regulated alternators, in some instances. That means there is one device that turns energy from the fan belt into electrical energy,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
