Posted by caterpillar guy on January 25, 2020 at 10:37:53 from (47.26.95.42):
In Reply to: Steiger Bearcat 2 posted by Plowhand on January 25, 2020 at 05:33:42:
I doubt you could bore a block for 8.00 a hole today. I think most of those engines were worn beyond the limits to not have to sleeve when they were shot. The block was to thin to bore without getting into the water jackets I think I heard something about back in the day. The later ones had sleeves in so resleeving was possible on them. Also was like a Detroit no lugging with out consequences. Just didn't have the torque for it. The inline 6 engines would pull better with few problems. Though I have heard the 3306 didn't stand up well in those tractors. I would believe it is due to it being pushed to it's upper limits to make the 260-270 hp where the 3406 was set to run from 280-460hp easily. With some I am sure running close to 600hp.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of David Brown Tractors - by Samuel Kennedy. I was born in 1950 and reared on my family�s 100 acre farm. It was a fairly typical Northern Ireland farm where the main enterprise was dairying but some pigs, poultry and sheep were also kept. Potatoes were grown for sale and oats were grown to be used for cattle and horse feeding. Up to about 1958 the dairy cows were fed hay with some turnips and after that grass silage was the main winter feed. That same year was the last in which flax was grown on the farm. Flax provided the fibre which w
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
