Posted by NC wayne on January 13, 2020 at 07:26:23 from (174.247.0.171):
In Reply to: hydralic cylinder posted by rick n ohio on January 12, 2020 at 17:18:46:
On a thumb cylinder you're not so much worried about the pressure the pump puts out as you are the pressure that will be caused in the cylinder if you curl the bucket into it. Both can blow seals, but the force generated from the bucket curling can easily bend the rod as well, if the relief doesn't pop first. I've seen it happen several times over the years.
With that in mind, the machine may run at XXX pressure, but you'll want to set the relief on the port going to the cylinder at no more than the pressure rating the cylinder is designed for.
Too, using generic numbers for an example, if you see you can use say a 2 1/2 inch cylinder at 3000 psi, I'd suggest stepping to a 3 inch at 2500. That will typically give you the strength of a larger rod diameter, and give you the power you need at a lower pressure, both of which are important on a thumb.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Show Coverage: Godfrey, Illinois Country Days - by Cindy Ladage. Except for last fourth of July's Old Gold show in Springfield, Illinois, I don't remember when it was so hot. Nevertheless, the heat didn't keep vendors and visitors alike from enjoying the third annual Country Day's Event. Jane Elliott said the event was originally a one man show. "Barry Seiler, owner of Country Town Farm Supply store used to invite people up to the Johne Deere store. He would give hats and a free meal for everyone that brings a tractor." Elliott said while this
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
