Posted by TWilliams on January 12, 2020 at 10:10:22 from (199.180.111.98):
In Reply to: Firewood Splitting posted by rusty6 on January 11, 2020 at 21:05:15:
We use a loader with pallet forks to load 18-20' lengths of wood onto farm wagons Haul them into our home farm. I have a heavy homemade 3 point hitch splitter. We saw up the load of wood into stove lengths and position the splitter next to and at the same level as the wagon so that we can simply roll the sawed lengths onto the splitter. We position another wagon on the opposite side of the splitter so that we can toss the split pieces onto it. No bending over, no lifting big chunks of wood. Can split a load of wood in no time. Thought I had a pic of the setup, but couldn't find any. But here's a load of red oak from a few years ago. A storm took it down, it was starting to rot at ground level. Some of the pieces were so big I used a wedge and sledge hammer to quarter them so I could manage them on the splitter. That was some nice clean stove wood.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
