Posted by Ark68SS on January 02, 2020 at 22:14:22 from (174.53.39.12):
In Reply to: numbers matching? posted by 47fivewindow on January 02, 2020 at 06:41:54:
I restored a '68 Chevelle SS396. The original restoration was paint/interior/mechanical rebuild/get it running to have fun. In 2004 I attended Chevelle-a-bration which was like the National Chevelle show. That's when I learned about "matching numbers" and decided to build my car to that standard. The car had almost all of its original parts, but over the years some had been replaced.
Many of the assemblies and parts on cars of that era have stamps that show the date the item was built, usually an alphanumeric code using letters for the month and numbers for the day. To be a numbers-matching part it needs to be built from 1 week to 2~3 months of the date of the car's manufacture. Some options that were not made in large numbers could be earlier. Engines and transmissions of GM products were stamped with a partial VIN that should match the VIN of the car. Engines were also stamped at the assembly plant with a two letter stamp that indicated the displacement, HP rating, and transmission application. These are the numbers that are frequently "restamped" by unscrupulous builders to add perceived value to the car.
Searching for and finding the parts I needed was a lot of fun for me. Not as much fun as driving the car to all the shows and meeting folks and seeing their cars. I guess that numbers matching added a little to the value of the car when I sold it, but it was mostly the quality of the build that brought the $$$. :)
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
