Posted by keith True on December 29, 2019 at 07:51:00 from (73.68.29.112):
In Reply to: Re: Good Riding Mower posted by DoubleO7 on December 29, 2019 at 06:56:59:
I don't think there is much difference in brands,EXCEPT,for dealer backup in your area.Other than that it is like changing deck chairs on the Titanic.The big thing is to keep it under cover.Not under a blue tarp in the yard.Humidity,rain,snow,sun,all seem to eat lawnmowers.I have a 73 Wheelhorse that has been here since new.It has been through a few new decks,some rear hubs,(they loosen and wallow out)and a set of rear wheels.The tractor had hubcaps and held the wet grass in.Also a half dozen tie rods.The original 12 HP Kohler engine has never once been apart.We think the carb has been replaced 4?maybe 5? times.The throttle shaft eggs the body out.It is starting to use oil now,about a cup in two hours.We're thinking now it might make to 50 years before the engine has to be done or replaced.It has been under cover since day one,It is always started at the lowest RPM possible,not raced up like so many people do,and is always idled a minute before shutting down.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Two-Brush Generators - by Chris Pratt. Whether for product liability or because the aftermarket parts and labor business is lucrative, this concept is disturbingly prevalent. Fortunately when you step into your shop and make that jump 50 years back in time to work with your old tractor, this concept goes out the window. Even so, when it comes to the charging system, people quickly revert to this idea and start replacing the major components one at a time until it works. The reason you don't find any decals in your replacement set wit
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.