Posted by Janicholson on December 27, 2019 at 17:23:28 from (24.240.46.228):
In Reply to: Farmall Super M posted by Curt2676 on December 27, 2019 at 11:29:03:
If it is 4 or 5 seconds quite normal, if 10 to 15 seconds it could be linkage. Make sure the pivots in the links from the hand lever to the strange little bell crank on the top left of the cylinder head are all pretty much not ovaled out. Next make sure the small springs in that little bell crank are in place with no looseness, and not over tight. Next have someone move the hand lever as you watch the governot lever on the back of the governor to assure it is moving with the lever. If this does not fix it. it could be the linkage inside that "elbow" like thing that attaches to the carb through a tube. or the governor as noted below. Jim
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Case VA Series - by Staff. V, VC, VI and VO). Althouh the Case VA looked much like the V, it shared no major components with its predecessor. Except for military units, the production of the Case VA was interrupted in July of 1942 due to World War II. It resumed again in 1944 and continued until 1953. It started up briefly later on in 1953 and continued on a very limited basis until 1956. The VA Series included the following models: VA: Fixed front wheel tread VAC:
... [Read Article]
Latest Ad:
Massey Ferguson model 65 diesel tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
