Posted by otis on December 24, 2019 at 13:34:02 from (50.38.214.146):
Merry Christmas to all of you!!! I am now assembling my JD "H" and am not sure about the timing of the cam to the crank. The cam and it's gear both have the "V" to align the gear to the cam, so that is clear. I found a very clear punch mark on the crank gear and a punch mark on the left side face (towards the flywheel) of the cam gear. The crank mark is on the back side of a tooth, while the cam mark is near the bottom of a tooth, but close to a "valley" Are these the punch marks used to align the cam to the crank? Also, is there a mark on the cam gear to time with the mag? Should the crank be in place when I put in the cam, align the cam gear to the crank, and then insert the cam into the cam gear? Thanks for any help for a novice!!! Otis
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Old Abe is Still Making Hay - by Jeremy Sweeten. Things have changed a bit since my last article. I am now almost finished graduate school at Purdue University. I am still in Agronomy, but specializing in hay and forages. My wife has survived two years of marriage to a part-time farmer. The equipment line up has changed a bit too. The DC has retired to
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
