Posted by Bob on December 20, 2019 at 19:20:31 from (64.255.159.199):
In Reply to: Head Bolts posted by Ted in NE-OH on December 20, 2019 at 18:40:25:
Quoting Removed, click Modern View to see
Oh, for gosh sakes, let's not get too carried away here, this is a little low-compression flathead gasoline engine putting out less than 3 HP per cylinder, and there's 17 head bolts to keep all that power under control!
To the O. P., grade 5 will be more than adequate, take a close look at the length of the threads to be sure it matches the originals.
That being said, head bolts can have some special characteristics, such as a reduced diameter between the head and the threads to give a specified amount of stretch/clamping force, and using the correct replacement bolts is never a bad idea, but for this little low compression, low HP engine I can't imagine having any problems using common bolts so long as the length and length of threads is the same as the originals, just my humble opinion.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
