Posted by Michael Soldan on December 20, 2019 at 09:25:58 from (148.170.140.200):
In Reply to: Buying Used Equipment posted by Vicinalvictor on December 20, 2019 at 06:48:08:
I bought a Massey haybine from a dealer. He had two exactly the same. He put a tractor on each one and let them run. He felt that one stood out as the better , tighter unit. Very reputable dealer. I took it and couldn't have been happier. It runs like a new unit. I replaced one tire a few years later and a drive belt. I bought two large hopper wagons from another dealer , cleaned and greased all the wheel bearings and good luck with them as well. Bought two Farmall H's from private sellers and great luck as well. I'm sure there are horror stories buying used. I always expect that there will be some maintenance to do on any used machinery, maybe a bearing or a belt. Never bought at consignment other than a cement mixer which turned out fine. Today is different than 20 years ago where you could trust what you were looking at.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Buying your first tractor: The People You Buy From - by Chris Pratt. If you are a first-time buyer, chances are that you are likely to take the word of the seller on things. This is where the problems start... You have reviewed your implement needs and determined the size of machine that will fit the bill and even made a list of the most desirable models. You checked on the availability of a 3-point hitch for the machines on the list and advertised in your local classified paper with so
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
