Posted by warbaby on December 09, 2019 at 06:01:15 from (24.180.81.247):
In Reply to: Re: Gibson tractor posted by bradley martin on December 09, 2019 at 03:40:26:
There's still a lot of them around because they are so damn hard to kill!
I have a few "D"s (a "D" will have 24 inch rear wheels, an "A" has 16 inch rears), I used to have an "SD" (it had a hood, but still had a tiller bar to steer with, the "Super D" had the hood and steering wheel). I also had an "E" which had a Wisconsin twin instead of the single and bull gears in the rear axle to lift it up to row crop height. The "E" was the size of a farmall cub. I shoulda kept that one.... They are neat little machines; everything is out in the open and ruggedly built. Water loves that rear axle casting though, it'll get in there and rust out the brake bands and destroy your ring and pinion. That hard-to-find ring and pinion can be replaced with one out of a B.F. Avery, Twin Row Wards or General tractor and is a direct bolt-in replacement EXCEPT for the pinion flange- you'll have to adapt it to your original drive line.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - by Teri Burkholder. The View from the Garage - Never a doubt, everything on our farm is a learning experience. I've been working very hard to get our two rundown Farmall A's sanded, primed , bondo�d, fiberglassed and painted before our big local tractor show called the Tulip Festival. My husband Ben came in the garage one rainy day to see if he could "help". Well if you knew Ben you wouldn't want him anywhere near your spray gun, fiberglass or bondo! So I pulled out the 2 old yucky looking magne
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
