Pick one or more of the following and then describe it more to us: I can put it in gear with the clutch pedal pushed down all the way but when i lift my foot off the pedal the tractor doesn't move. I push the pedal down all the way but the gears never stop turning it grinds bad. I push the pedal down all the way but the gears won't go in for at least 5 seconds of grinding. It seems normal until I pull something or go up a hill in a higher gear then it slows or stops. The tractor won't move till the pedal is very close to all the way up. I can't put it in gear unless the pedal is all the way down, then it moves right away when the pedal is still way down. It makes this rattley noise when my foot is on the pedal and I push a little. It makes this rattley noise when my foot is off the pedal, but not when I push it down , even a little. It is easy to push the pedal (I feel no resistance but a light spring) and it grinds. It feels normal on the pedal, but it i start it in gear it moves with the pedal down.
These are common issues and we sure can help. Are you an experienced manual transmission driver, car, truck, tractor? Jim
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.