Posted by John T on December 05, 2019 at 15:41:47 from (174.207.18.91):
In Reply to: Tractor will not fire posted by Steve57 on December 05, 2019 at 15:19:36:
If you're talking about the starter solenoid ??????????????? sure the INPUT is a big battery cable coming down from the battery while the OUTPUT wirers to the starter motor. On many it takes a 12 volt signal down from the START position on a switch to engage and close the solenoid contacts so the starter motor cranks and turns the engine over. If that wire is open or there's no 12 volts down from the starter switch or the solenoid case/frame isn't grounded it wont engage. Its possible to use a jumper wire to jump from the hot INPUT side over to the small S activation terminal on some solenoids to make them engage and there still needs to be a good ground.
You talking about the solenoid or talking about there's no fire at the plugs??????
You may not even have this type of a starter solenoid Im talking about so I need more info to help more
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
