Posted by JD Seller on November 30, 2019 at 18:57:57 from (208.126.198.213):
In Reply to: Rosie the riviter posted by Grandpa love on November 30, 2019 at 18:27:16:
Tractor plants greatly reduced tractor manufacturing and made other stuff for the war effort. Yes there would have been a raise of women working in the tractor plants too.
Around 16 million US men fought in WWII. That was around 11% of the total population. Then you think about how these would have all been in there 20-30s that is a huge chunk of the work force of the time.
I am still amazed at how the US was able to turn its manufacturing focus to the war effort in such a short time period. Then look at how much material the factories produced.
In just airplanes alone the US made 280,000 planes. 97,000 of them bombers. A single plant, Fords Willow Run Plant, made 8700 B-24 in one plant. At its peak production it completed a new B-24 every 63 minutes.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.