Not sure what you are trying to say. Frame mounted cultivators were predominant around here during the 1950's. Had to look real hard to find a rear mount. If a guy had fast hitch tools and traded off say an IH 400 for a 2510 JD most of the time the farmer spent a few hours with the torch and welder and converted the implement to 3pt operation. Cut the tongs short and burn holes for the lower lift arm pins then build a mast for the top link complete with bracing. But as I said before by the mid- 1950's 3pt implements were already waning. Nobody was trying to use a 15ft 3pt disk on a 730 JD tractor. Nearly all implements if not fully integral were drawbar pulled for tractors above 30 HP which was an increasing share of the market. OK, you have a 706 and 1206 but are running down the TA? The neighbor had a few TA equipped IH's and they were not in the shop all that frequently never mind for TA repair. For the mechanical TA's if you read the book a farmer would realize that there is periodic service to keep the TA in good working order. Yes, eventually they needed repair but then so did the Oliver over-under and down the line. Back to the fast hitch if a farmer did the reverse and already had 3pt implements and bought a fast hitch equipped IH tractor he either built an adapter or went to Central Tractor and bought an adapter for 40 dollars. The fast hitch certainly did not do IH in.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - Tractor Engine Repair - by Teri Burkholder. One of the great things about working on a tractor engine with your other half is that you know what he is thinking of at all times and can anticipate his every move and his next thought of what he will do. With Ben, anyway, I can tell! He'll be busy working and I�m handing him tools and he says, "give me that..." and I�ve already got it in his hand or "hand me that....."and I�ve got the portable light right where he needed it placed to see. "Run in the house and get me a...."as I open th
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
