Posted by Stephen Newell on November 29, 2019 at 16:07:58 from (107.77.199.229):
In Reply to: Re: I don't get it II posted by Janicholson on November 29, 2019 at 14:40:15:
The keeper and valve spring is still in place. It's just the spring had broken and is still putting pressure on the valve to close. Just not as much as it should.
I don't believe I've lost any parts. That valve except for the broken spring looks just like all the rest.
The parts book I have doesn't show a snap ring. It shows a split keeper holding the cap but I can't see any trace of those on the tractor. All you can see on the valves is the snap ring.
I've got the piston rotated in the up position so the valve wouldn't fall very far.
I got to wondering about how to compress the new spring. I saw a video where a guy put zip ties on the spring and compressed it in a vice and tightened the zip ties as he went. I have yet to determine how much pressure is left in the broken spring.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
