Posted by Brent Zappe on November 28, 2019 at 07:03:30 from (104.192.90.130):
In Reply to: Allis will not start posted by FtInn Farmer on November 27, 2019 at 16:41:26:
these are things in the past I have found wrong with a Magneto Fairbanks type. 1 gasket has to be the thick one not thin. Because it needs clearance or the rotor nylon wheel will hang up. Than the nylon wheel that rides the gear gets striped. 2. Check and make Shure the rotor inside of big cap moves around on this nylon rotor as the engine cranks. 3. get a spark tester hook up to the spark plug wires crank the engine around looking at the spark tester to see if you have spar on that cylinder. The problem is the nylon rotor gear on the big black cap will some times strip a tooth and cause it to not turn but stick in one position. Just some thing to think about good luck. Referring to Hot to restore Tractor Magnetos by Neil Yerigan.page 89-94 in the book.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
