Posted by caterpillar guy on November 27, 2019 at 02:09:27 from (47.26.95.42):
In Reply to: Dry climate posted by DeltaRed on November 25, 2019 at 07:23:14:
Delta, Bmack, and mptaszynski, I've been to all of your parts of the world at one time or another. Went through Delta in the middle of winter, from ID through Grand Junction, to Hwy 114 then down the gun barrel to Monte Vista. Over to Alamosa. Then a week later back through the same route then back to ID again with the rest of the Air seeder I took up the first trip. The First trip I had to go the long way around up through Denver to Cheyenne across to ID as the road were closed for oversize travel. For the other trip it was summer time, maybe spring. Went up to Probably Salt Lake. Took 491 from Gallup up to Cortez, then on to UT. Was a very pretty trip. Stopped at one of the little places was a store there might have been Dove Creek been a few years and was to busy enjoying the scenery.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Two-Brush Generators - by Chris Pratt. Whether for product liability or because the aftermarket parts and labor business is lucrative, this concept is disturbingly prevalent. Fortunately when you step into your shop and make that jump 50 years back in time to work with your old tractor, this concept goes out the window. Even so, when it comes to the charging system, people quickly revert to this idea and start replacing the major components one at a time until it works. The reason you don't find any decals in your replacement set wit
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
