Posted by Geo-TH,In on November 19, 2019 at 15:36:24 from (184.19.52.215):
In Reply to: Re: Brush guard posted by Adirondack case guy on November 19, 2019 at 14:42:39:
Loren, You are the master when it comes to building things. I'm just a redneck. Many things I build are proto-types which will be modified as needed. I used 1/2 bolts on the main sections. I was also concerned about weight and removing it from bucket in one piece. I may someday weld it together and remove it with the terramite's bucket. No way can I lift it welded together. I really think what I have will be better than 44 inch wide factory forks. My one terramite has 48 inch bucket, other has 54 inch bucket, Kubota has 72 inch wide bucket. The wider the easier is will be to balance logs on forks. I also have a way adjust width of forks to be less than 72 inches. geo
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Piston Ring Removal and Replacement - by Chris Pratt. Piston Ring Removal and Replacement - Replacing rings is a fairly easy process to stretch the engines usability between major rebuilds and cut down on that blue smoke and high oil consumption. Frequently, replacing only the rings is not advisable because by the time you do the teardown and measurement of the components, the pistons are often beyond the manufacturers specification or something else you find will signify the need for a major rebu
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
