|
Tractor Talk Discussion Board |
Re: projects around the place
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ken McWilliams on January 22, 2002 at 05:35:30 from (152.163.201.46):
In Reply to: projects around the place posted by sod on January 21, 2002 at 20:11:49:
Sod, That is a very generous offer. Where are you located? I started a barn several years ago. The material is from a steel mezzanine out of a factory. The posts are 6X6 steel tube, the "trusses" are 14" I-beams. The peaks are to be welded and the "trusses" bolt to the posts with pre-welded flanges. The trusses are mitered and ready to do the finish welding. I even bought a new 18" auger for the footings. Then the wife says I'm too old to get up on the barn and do the work. Now I'm laid off from my job with lots of time, but no money. It was to be 50 X 60, but the sheetmetal alone is $8K. I guess I'll keep dreaming. Ken McWilliams Dayton, Oh
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Product Review: Lead Substitutes - by Mike Schordine. Lead was oriinally added to gasoline as an upper cylinder lubricant. It lubes the valves and seats. If you rebuild the motor, you could use hardened seats and valves, and unleaded fuel. But if your old tractor runs good, a simple lead substitute added to the gas is a perfectly reasonable solution. And, if you are like me, your tractor is under cover, but it sits outside. So with every temperature change, the humidity in the air collects in the fuel tank, in the form of water.
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|