Posted by andy r on November 08, 2019 at 21:45:47 from (208.126.193.44):
I posted a week or so ago about my John Deere 6620 sidehill combine seemingly slowing down and not reaching the maximum mph in each gear. I had mentioned that it seemed like the reverse side of the hydro worked at a normal mph. What I found was the very end of the cable connecting the hydro cab lever and the hydro itself had failed. The last 5 or 6 inches of the cable is metal and had loosened from the flexible part of the cable. So when you pushed the lever forward to move faster the cable would push the linkage at the hydro a small amount then would just make a big kink (since it wasn't supported) in the inner cable not pushing the linkage all of the way. In reverse it was pulling the cable and would move the linkage the full extent. There was no chance for a kink since it was pulling on the cable. The repair was to get some automotive hose, slit it open, fit it over the flexible cable and the metal end, and clamp down with small hose clamps. The end of the cable is now supported and the inner cable cannot flex therefore pushing the inner cable all of the way. Before next season I will replace the entire cable.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Torque Wrenches - by Curtis Von Fange. When working with fasteners a torque wrench can play an important role in the correct assembly of critical equipment components. Lets examine in detail some of the reasons for using a torque wrench along with how to correctly use the variety of wrenches available. Applying the proper torque to a fastener accomplishes a number of tasks. First of all correct torque will hold the parts together. This may seem like a trite statement but � think about it for a second. Engineers have designed
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
