Posted by Brent Zappe on November 06, 2019 at 07:20:30 from (104.192.91.194):
Brent's thoughts of hard knock school. Within that past years I have to learn these things the hard way. So here are a few things that might help us out (I hope). 1- making Shure the exhaust stack clapper is tight and secure before starting up engine. How many times I have had hit me in the head because I did not check them. 2- Making Shure the kill switch for the magneto is set in the on position. Some of us have these tricky switches that ground out our magnetos. Check them before you pull off that Magneto and start working on it. 3- Making Shure the tractor is out of gear before starting it up. How many times we at tractor show forget to make Shure of this one. Is it funny how the tractor always starts up with the first hit on the starter in gear. 4-When you think you have failed on what your working one. Always remember that it is batter than what it was when you fist started. 5- You never have enough tractors (L.O.L). Stopping in no where looking at tractors is okay. for guys like use that is showing that we are Normal. So that is what I have learned so far since 1994 with working with tractors. I know I have gone threw the Hard Knock Collage of tractors. It is one enjoyable school to go threw. I would do it again and I know I learned computer and watch this site grow. Yesterday tractors is better than ever know not like it was back in 1995 when I first got the internet hooked up. thank you tractor guys like use we did it.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
