Posted by John T on November 05, 2019 at 04:29:34 from (107.77.207.21):
In Reply to: Question for JohnT posted by moonlite37 on November 05, 2019 at 04:16:06:
Moonlite, "electronics" (versus tractor DC and AC power distribution) is NOT my cup o tea, its been too long lol
Wayyyyyyyy back in the old days with tube car radios a noisy humming Vibrator pulsed the battery DC and a step up transformer increased voltage BUT THATS WAY OLD TECHNOLOGY.
I cheated and found this article which describes DC to DC Converters as Linear or Inductive Switchers and it explains this muchhhhhhhhhhhhhhhhh better then I ever could.
Not to worry, since its an electrical question I'm confident you will get a ton of answers hopefully from some "electronics" experts who are more current then myself who can better answer or research the topic for you. I'm short on time I'm heading SOUTH today.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Massey Ferguson 35 (and up) Tractor Assembly Notes - by Jack Wetmore. These assembly notes are for Massey Ferguson tractors with a two stage clutch and 6 speed, 8 speed and mutli-power transmissions. I see a lot of discussion forum messages regarding damaged clutches from improper assembly. The objective is to have the engine and transmission slide together safely and easily until the gap between the two halves is less than 1/4", BEFORE tightening any of the bolts holding the two together. Using bolts to draw the two halves together will damage the PTO
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
