Tractor Talk Discussion Board |
Re: Re: Allison transmission question
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Canadian Cowboy on January 15, 2002 at 22:21:47 from (209.53.125.186):
In Reply to: Re: Allison transmission question posted by Jack in Fla on January 15, 2002 at 16:20:44:
Jack, Now that sounds like an awsome truck, Id sure like to see a picture of it. just a few question how did you go about getting a drive shaft to the last axle in the rearend??? are you running two transfer cases??? Did you move the original rear axle forward or kept it stock??. What did you do to plumb braking into the rearest axle, just T'd into the line going to the stock axle?? Sounds like that truck would handle the steeps grades around my parts, some hills make a bone stock powerstroke suck wind, not much of a load behind trailering either.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Crank Start a Tractor - by Staff. This interestin discussion is from the Tractor Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|