Posted by Skyhighballoon(MO) on October 10, 2019 at 14:45:55 from (135.245.48.76):
In Reply to: C-65 Brakes posted by MF165FARMER on October 10, 2019 at 08:48:32:
I bought a 75 C65 grain truck a few years ago and had to go through the brakes. I replaced the master cylinder, hydrovac unit under the cab and both wheel cylinders in the left front and right rear wheels. I got all my parts from Napa but you might find some online if you know part numbers.
Not only do you have to bleed it well starting at the master cylinder, then at the hydro unit then at each wheel, you also need to jack up each wheel and turn the little star adjusters to get the shoes as close as you can to the drums w/o dragging. This reduces the amount of fluid the master cylinder has to push to get braking action. I have brakes on the first push but it's close to the floor even after fixing and adjusting. 2nd pump I have a full firm pedal.
The standard master cylinder has a 1.5" piston if I remember right. I remember looking around on Rock Auto and finding an optional master cylinder with a 1.75" piston that looked like it would fit. That larger piston would move more fluid when pushed the pedal and might help eliminate some of the pumping.
I also have a 74 C60 and it doesn't have the same mushy pedal issue...go figure...I just think think there is enough give in all the tolerences in the system that it takes a LOT of adjustment to get really good brakes on these old trucks...some harder to get than others.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
