George with the powder dry dirt your going to have under the slab I think your going to have cracks. The sad fact is it is going to move regardless of what you do to the pour. That being said I like fiber glass in floors IF your not wanting a really smooth finish. The fiber glass will stick up after it is finished and it will have wear off to be really smooth. The fiberglass will not stop deep cracks either. What it is very good for is shallow surface flaking and such. You also do not have to use as much rebar.
We just poured 3500 mix with 1/2 rebar on 3 foot centers, with fiber glass 5 1/2 inches deep, at my Grand daughter's. The rebar will keep the deep cracks from shifting levels and the fiberglass will keep the surface for flaking off. We just floated it off. We wanted a rough finish for livestock to walk on but not a broom finish.
The fiber glass is great for sidewalks. as the little rougher finish is not near as slick to walk on wet.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
