Well even the smallest fork truck mast would easily lift 2000-3000 lbs. Just make sure and find a double section mast. Meaning it has a second section so it will lift higher. A single section would usually not lift ten feet. A double would easily. A triple usually goes to over 20 feet.
As for motor size. Unless you put a really large capacity hydraulic pump on it, a few HP motor would be enough.
You need to think about your hydraulic setup. 1) Fork truck masts are single acting. So you will need a Single acting control valve. 2) since the cylinder is single acting you will need an oil tank to be large enough to hold enough oil to completely fill the cylinder.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Piston Ring Removal and Replacement - by Chris Pratt. Piston Ring Removal and Replacement - Replacing rings is a fairly easy process to stretch the engines usability between major rebuilds and cut down on that blue smoke and high oil consumption. Frequently, replacing only the rings is not advisable because by the time you do the teardown and measurement of the components, the pistons are often beyond the manufacturers specification or something else you find will signify the need for a major rebu
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
