Posted by SweetFeet on September 23, 2019 at 07:13:44 from (70.35.102.196):
In Reply to: Re: Fall is here--- posted by Russ from MN on September 23, 2019 at 05:59:42:
Bicycling is great exercise... but I wish they'd move over to the shoulder when a vehicle approaches. It is frustrating to be trapped behind them in areas where one cannot pass - toss in some curves and/or hills and a driver can be stuck behind them for a length of time. THEN add in the masses that participate in RAGBRAI and it becomes a ridiculous mess.
To me it's kind of like pedestrian crosswalks... Yes, I have a right to walk out of a store and enter a crosswalk, making an oncoming vehicle stop. But in my opinion, just because I can - doesn't mean I should. I refrain from doing it for two reasons: courtesy and for my own personal safety. Sure, I have the right-of-way, but if hit by a car in a crosswalk - I KNOW who's gonna be on the losing end. Me.
So I think the same thing regarding bicyclists: Sure you may have the right to be in the traffic lane but if a cyclist gets hit by an auto, THEY will be the ones getting the worst end of it.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
