Posted by Determined on September 21, 2019 at 07:11:23 from (216.130.212.201):
In Reply to: two speed posted by stonerock on September 21, 2019 at 03:34:27:
Had a truck that did the same thing, problem is it would only do it randomly and sometimes it would go for months without a problem.
Had checked all the connections and obvious things.
Finally one day while out on the road, just as I shifted gears the rear axle popped into neutral and at that point it would not go back into high or low.
Being dead in the water on the side of the road I crawled under and removed the cover from the box of the shift motor, turned the worm screw until the block that rides on it was at the end of it's travel then stuffed a rag in tight so the block could not move and put the cover back on.
It got me home and I decided that for what I use the truck for I really did not need to have low range, that was 3 or 4 years ago and it has never acted up since.
Not by any means a fix if you need to have the 2 speed functioning but it will get you home in a pinch.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
