Posted by super99 on September 08, 2019 at 17:08:52 from (50.109.82.247):
I wanted to add a transmission temp guage to my 98 Chevy 3500 tractor hauler, so I picked up a sending unit and electric guage at Napa. Couldn't figure out where to get power from, so there are 3 power ports in the dash, I took the power cord off of a heater that plugged in that way and used it to power the guage. It has a fuse in the line, so I am pretty sure that I hooked up the guage right. Got the sending unit put in the line this afternoon, started it up and let it run for a few minutes, plugged in the temp guage and it immediately pegged the needle to the hot mark on the guage. Where did I go wrong?? Are the guage and sending unit not compatible? Do I have the wires hooked up wrong? There are only 3 studs on the guage, pretty sure I hooked them up right but ran out of time today. I'll pull the guage tomorrow and check wiring. Any ideas?? Only planned to use the guage when pulling the trailer. Thanks, Chris
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Running Beans in East Central Indiana - by The Red, John Fritz. Fall is my second favorite season behind the long days of summer. The calendar reads late September and it�s time to start running beans. This article is about my experiences helping my farm neighbor Ernie Swoveland, along with his grandsons Jeff and Craig Ring, with the soybean harvest in East Central Indiana for the 1999 season.
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
