I developed a roll of b&w through a Rite-Aid when I was living in Washington about three years ago when my chem's expired/burned out. The prints turned out nice, not exactly $15 nice. It also took an extra week & a half to get back & no negatives. No notice on extra handling time for b&w either. Which is entirely ridiculous. I sent in a roll of BW400CN, a C-41 b&w film that gets dev'd in a standard dime-store developing machine. I was a bit irritated & emailed Rite-Aid's corporate. I actually got a nice response with the phone number of their developing lab. I did call aaaaaand.... not even going to touch on the phone conversation with the foul-mouthed, uppity broad at the Fujifilm lab in PA. And believe me, "broad" is a word I seldom ever use.
Currently developing on my own, for about 65¢ a roll, average. ECN-2 for movie film is about another 20¢. That soup combo is pricey!
OM-10 by the way, great camera. Hope to have one in my collection some day.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
