Tractor Talk Discussion Board |
Re: clutch wont disengage
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mark Hendershot on December 19, 2001 at 16:10:35 from (216.166.150.156):
In Reply to: clutch wont disengage posted by Gene on December 19, 2001 at 15:36:17:
Check to make sure the clutch pedal only goes down 1/4 to 1/2 in. to take up the slack befor starting to disingage the clutch. Also if the pedal is adjusted correctly, the disk might be frozen to the flywheel(if cold enought) if warm then maybe rusted but you should be able to brake it loose buy driving it. If the pedal goes down with out any forse needed it might have got loose (the bolt that clamps it) Need more info dose the pedal go down? ECT. Put it in 4th gear while the engine is off and rock it while someone holds the clutch pedal down that might break it free. Mark H.
Follow Ups:
Home
| Forums
Today's Featured Article -
What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|