Posted by tomstractorsandtoys on July 31, 2019 at 16:56:55 from (50.123.209.122):
I have a model 30 bale thrower on my 24t baler. Have owned for over 25 years. Today when baling the distance became erratic. Sometimes with it on 6 the bales would go to the back of the wagon and sometimes barely over the front. By the time I quit it was doing the same thing on 8 sometimes hitting the back and sometimes just over the front. We are baling straw that has no wet spots or heavy bunches. The 2 drive belts are tight and there is plenty of oil in the thrower tank. It is new hyd oil as we had a leak in a line last summer. When the oil was out the filter appeared very clean. Where do I start? The operaters manual gives no ideas. I remember my old Deere dealer talked about taking the distance control valve apart and adding a small amount of grease every few years. When we baled lots of small bales we would take it to the dealer every two or so years and have it completly gone over. Now that we moved and only bale 2500 or so a year we haven't done that for awhile. Any ides? We have 1500 or more bales of straw to make and the weather is good right now. Thanks Tom.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Fordson F Ignition System - by Anthony West. A fellow restorer contacted me earlier this year asking for some help and advice on a model F that he was restoring. He had over a period of months spent a fair amount of his hard earned cash on replacement parts for the old "trembler" ignition. Sadly though all his efforts seemed to be a waste of time and money as he still couldn''t get the temperamental old thing to run correctly!! If i said that this was a little frustrating for him that would be "conservative" in fact the problem had reduce
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
