|
Tractor Talk Discussion Board |
Re: 1970 Ford 2000 flow control adjustment
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RWK in WI on December 13, 2001 at 17:21:00 from (169.207.136.32):
In Reply to: 1970 Ford 2000 flow control adjustment posted by Dave in Missouri on December 13, 2001 at 09:07:16:
When you say lever below the seat I think you
are refering to the lever that changes from
position control to draft control. Counter
clockwise for position - clockwise for draft --
Yes, I know a lot will say up for position and
down for draft but two of my tractors have their
levers in different positons.
Flow control - if you have it - could either be at
the pump ( 4 cylinder tractors ) or a round
valve on the right side of the transmission ( 3
cylinder tractors ) that you turn like a water
valve.
I hope this helps you.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
A Tractor's Point of View - by John Manley. I began my life on August 3,1941. I was actually built at different times and days but I was officially an M Farmall on August 3.I was real nice and shiny. That�s me, in the old picture, third from the left. I was loaded on that train and sent to a little town in South Carolina. I didn�t get to see much of that town. I was moved off the train fast and on to the dealer�s
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
