Posted by Leroy on July 21, 2019 at 07:17:38 from (96.45.243.241):
In Reply to: Re: Finish mower posted by Grandpa love on July 20, 2019 at 18:41:37:
Double check the length on the drawbar, has to be same length as your other 3 point implements. They are not clear as to exactly what is the one for the 9-2-8N tractors as they have them all mixed up in the listings with the sizes for a 7-8000 listed in section for the N series and the one is I think for the little subcompact 1000 tractor. The stay bars the red will work same as the blue but they were higher priced and I think blue would look better on a battleship grey tractor. If buying those items look at the chain that holds the quadrant lever down so if the lever does get moved with PTO happening to be running will not bend everything else up. I have a 41 9N and a 44 2N bought new in may of 44. Had a NAA and a TO-30 Ferguson and same parts fit all of them. Might find those parts listed better under one of the other models.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
